Verify that the LabelWriter software installation process completed successfully before you plug the USB cable into your computer. Close the printer cover so the roll feeds into place. Tuck the label guide against the right edge of the label stock. Line up the label stock against the left edge of the feed slot inside the front of the printer and insert it in the slot. The labels must roll toward the front of the unit from underneath the spool to feed correctly. Lift the printer cover and insert the filled spool into the slot on its underside. Press the spool guide on the spindle until the guide fits snugly against the roll of label stock. Pull apart the supplied two-piece label spool and insert a roll of labels onto the spool spindle. When you set the unit back on its base, verify that the wiring you've plugged in doesn't interfere with the unit's ability to sit flat on your desktop. Turn the printer over and plug the USB cable into the port on the bottom, immediately to the left of the power cable. Plug the power adapter into a wall outlet or power strip. Plug the right-angled plug on the end of the power adapter's cord into the outlet on the bottom of the printer, then feed the cord through the cable channel. The power cord that plugs into an electrical outlet also plugs into the power adapter. Plug the printer's two-piece power adapter together.
Dymo labelwriter wireless setup install#
If you're using QuickBooks 2007 or later, you can also install the printer's QuickBooks add-in. Load the printer's software CD-ROM into your optical media drive, then launch the installer and follow its instructions.
0 kommentar(er)
